Product Code:	49416
Availability:	In stock

This mount fits:

• Smith & Wesson Model 52

This mount does not fit:

• Smith & Wesson Model 41

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw

Red Dot Fitment:   

• Vortex Defender Series
• OSight SE
• Bushnell RXS-100   
• Crimson Trace CTS-1500   
• Holosun 407K*
• Holosun 407k-GR
• Holosun 507K*
• Holosun 507k-GR
• Holosun EPS-GR*   
• Holosun EPS-RD*   
• Holosun EPS-Carry-GR*   
• Holosun EPS-Carry-RD*   
• Jpoint   
• Leupold Delta Point Pro   
• Optima   
• Redfield Accelerator   
• Shield RMS  
• Shield RMSc   
• Shield SMS   
• Sig Romeo Zero

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.